The splice durability is a key to the belt life. Which splice is the best way is to rely on the flexibility and the splicing difficulty.
The hot splice is the most durable and flexible type of splice.
¢ÙZ-splice
The most stringent requirements for uniformity of thickness is mostly handled with Z-splice.
Suitable for knife-edge belts, this method is a standard belt splice of mono-layer and two fabric plies.
¢ÚStepped Z-splice
In the harsh operating conditions(e.g.dirty drums), the joints also keep up with the operation.
Same properties as the Z-splice, further used in two and three fabric plies types.
¢ÛWedge splice
Splice way used for solid-woven belts and NOVO types.
¢ÜOverlap splice
Especially suitable for two and three fabric plies belts with duroplastic coating.
Cold-press method
This method is possible for fitting and repairing on-site, but the splice strength and flexibility must be paid attention to.
Machanical fasteners
Machanical fasteners make it possible as follows:
---install rapidly dispensed with dismantling the conveyor or machine
---repair by inserting the same material only when damaged section
---joint speedily and easily
Advisable fastners:
¢Ý¡ªhook fasteners
¢Þ¡ªclamp fasteners
¢ß¡ªplastic fasteners
Fasteners can be inserted or hot spliced into the belt coating.
Further information for your request.
